How to Install a 36-Inch Monitor Industrial Pitless Unit: A Step-by-Step Guide.

The spool assembly contains openings that allow various components to pass through, including electrical wiring and equipment used to monitor water levels.

Depending on the well system, an air test line or pressure transducer may be installed. These components can provide information about the water level inside the well.

A probe tube or conduit may be used to simplify installation of certain monitoring equipment. The exact arrangement will depend on the type of monitoring system being used.

After confirming that the wires, tubing, and other components are correctly positioned, carefully lower the spool assembly into the discharge body.

The spool should seat properly without forcing or damaging any of the components passing through it.

Once the spool is fully seated, tighten the hold-down hooks. These components help keep the spool assembly securely in position and prevent unwanted movement.

Completing the Installation

The final electrical connections can now be completed according to the applicable electrical requirements and equipment manufacturer's instructions.

Before installing the cap, inspect the entire assembly. Check the discharge connection, pipe connections, electrical wiring, sealing surfaces, and monitoring lines.

The pitless unit cap can then be installed once the required checks have been completed.

The area around the well can be finished according to the project requirements. Make sure the completed installation provides adequate protection for the well and allows appropriate access for future maintenance.

Final Inspection and Maintenance