Globhy
AllBusinessHealthMarketingTechnologyTravelUncategorized
Posted on 13 minutes agoEdited on 13 minutes ago

Share:

UHF Military SATCOM Antenna: Why Choose Helical Designs?

UHF Military SATCOM Antenna: Why Choose Helical Designs?

AH-312 UHF military SATCOM helical antenna: 240-380 MHz, 12 dBic, RHCP/LHCP versions, 360° azimuth, 0-70° elevation, with stacked array options.

A ground station UHF military SATCOM antenna has to communicate with satellites at various elevation angles. It is designed to accommodate changes in signal orientation during transmission. The performance of the satellite link is determined by the frequency range, polarisation and pointing capabilities of the antenna.

 

This band is designed throughout with helical because it is practical. Why and polarisation mounting range and stacked arrays are explained in this post. It does not say helical antennas are superior to any other option. It shows where the design fits in nicely.

 

Understanding UHF Military SATCOM Antennas

The AH-312 described here operates in the UHF SATCOM band, 240 to 380 MHz. A UHF military SATCOM antenna at the ground end must cover that range and match the satellite's polarisation. Pointing is important too. In case you need the basics first, read what is a SATCOM antenna?

 

Why Helical Designs Are Used for UHF SATCOM

Helical antennas are made from a conductor in the form of a spiral. When in axial mode it radiates circularly polarised waves along its axis. Helical antennas are therefore used in satellite communications where the circular polarisation can accommodate changes in the orientation of the antenna and the satellite. If the satellite is not pointing in the same direction as a linear antenna on the ground, the signal will be lost. A circularly polarised helical antenna is much less susceptible to that mismatch.

 

The helix also provides directional gain along the axis of the helix, so that ground stations can aim their reception in the direction of the satellite. This directional gain helps installers point the antenna towards the satellite. There are other UHF SATCOM designs too. The helix is suitable for ground stations requiring circular polarisation and aimable gain.

 

RHCP vs LHCP: Choosing the Correct Polarisation

Circular polarisation is rotating either clockwise or anti clockwise. RHCP (right-hand circular) and LHCP (left-hand circular) are opposite to each other. Even if the frequency and pointing are right, an antenna with the wrong polarisation will only pick up a weak signal. The circular polarised helical antenna must have the right polarisation to match the satellite signal.

 

There are 2 versions of AH-312. AH-312-LHCP and AH-312-RHCP. Please check satellite polarisation before ordering or installation. Check the polarisation requirements for the whole communication system including the transmitter antenna and the receiver. Don’t just pick one because of how the antenna is physically orientated. Look in the sat specs or system docs for the required polarisation. Then you will not lose signal and you will not have to make changes in the installation.

 

Azimuth, Elevation and Satellite Positioning

The AH-312 mount offers 360 degrees of azimuth rotation and 0 to 70 degrees of elevation adjustment. Azimuth allows installers to aim in any compass direction. The range of elevation goes from satellites high overhead to ones low on the horizon.

 

Low angle paths go through more atmosphere. They can be blocked by terrain and buildings. So, site clearance is as important as the angle you are able to set it to.

 

This flexibility is useful when one design has to be used at different sites and for different satellites. The installer can adjust the antenna's azimuth and elevation to match the satellite's position rather than relying on a fixed pointing angle.

 

Share:

More in Technology

View category